9.6. Odour Removing Operation
•
• •
•
During stop condition, or cooling operation, when pushing the [ODOUR] button for 5 second, operation change to the odour
removing operation.
•
• •
•
Operation detail is as follows;
Fan mode operation for 180 second, then refrigerant cycle change to heating mode for 720 second, to heat up (dry) the indoor
unit. Compressor frequency and indoor fan controlled to maintain the indoor heat exchanger temperature 41°C.
•
• •
•
Indoor fan revolution is fixed (for DC motor type, fan speed is Slo, for AC motor type, fan speed is Lo), and indoor louver angle
is fixed manual set no.1.
•
• •
•
After that, fan mode operation continue for 360 second, then odour removing operation finish.
•
• •
•
During odour removing operation, [ODOUR] sign is blinking at LCD display panel of wired remote controller ([ODOUR WASH]
sign is not displayed for wireless remote controller), when pushing the operation button, or [ODOUR] button, odour removing
operation finish and set the odour cut operation.
31
CS-F24DB4E5 CU-L24DBE5 / CS-F28DB4E5 CU-L28DBE5
To Next Page
Loading...
Need help?
General
