Panasonic CS-F50DTE5 Service Manual

82
[Manual setting]
10.7.5. Emergency operation
• If you do not have the wireless remote controller (because the batteries are weak, or some other reason prevents the wireless
remote controller from being used), emergency operation can be carried out at receptor unit.
• Press the AUTO switch to start emergency operation.
Press the AUTO switch once more to stop emergency operation.
• Press the AUTO switch continue 5 seconds to start cooling operation.
Again press the AUTO switch continue 5 seconds to start heating operation.
• The setting temperature, fan speed and louver control will be fixed at the settings shown in the table below.
• While the indoor unit is running, the OPERATION indicator on the receptor unit will illuminate, and it will switch off when the
indoor units stops.
• Heating operation is not available for indoor units which are for cooling only. (If set to HEAT, the setting will change to FAN
instead.)
Please refer to the instruction manual provided with the indoor unit for instruction on how to use the wireless remote controller.
Operation mode Fan speed Louver
Cooling Hi Previous setting
Heating Hi Previous setting
Instructions for users

Panasonic CS-F50DTE5 Specifications

General

Indoor unit type	Ceiling
Indoor unit weight	47000 g
Indoor units quantity	1
Indoor unit dimensions (WxDxH)	1600 x 700 x 250 mm
Indoor unit noise level (high speed)	50 dB
Outdoor unit weight	105000 g
Outdoor unit noise level	56 dB
Outdoor unit dimensions (WxDxH)	900 x 320 x 1340 mm
Hose length (max)	50 m
Inverter technology	Yes
Refrigerating medium	R410A
Cooling capacity (max)	47700 BTU/h
Heating capacity (max)	54600 BTU/h
Air conditioner functions	Cooling, Heating
Cooling capacity in watts (max)	14000 W
Heating capacity in watts (max)	16000 W
Cooling energy efficiency (EER, W/W)	2.91
Heating energy efficiency (COP, W/W)	3.41