– 61 –
CS-G93KE
c. Outdoor Electronic Controller Removal Procedure
1. Remove the top panel and front panel
2. Remove the Outdoor Electronic Controller
1 Remove screw
Servicing Information
!
WARNING
• Be save to return the wiring to its original
position
• There are many high voltage compo-
nents within the heat sink cover so never
touch the interior during operation. Wait
at least two minutes after power has
been turned off.
Fig. 23
Fig. 21
Fig. 22
Fig. 20
4 Remove 2 screws
2 Remove 2 screws
6 Remove 5 screws
7 Disconnect all connectors
5 Remove Front
Panel
3 Remove Top Panel
! Warning ! Do not touch High Voltage Area
Note : Use magnetic type of screw driver to
avoid dropping of the screws
8 Remove the
electronic
controller
! Caution! When handling electronic
controller, be careful of electrostatic
discharge.
Untitled-1 6/21/00, 9:24 AM61
To Next Page
Loading...
