HELPFUL INFORMATION
Auto Operation Button
■
Automatic Operation
• If the remote control fails to function or misplaced,
press Auto Operation button for Automatic operation.
• The Automatic operation will be activated immediately once the Auto
operation button is pressed. However, temperature cannot be
adjusted in this operation.
• The power LED on the indoor unit blinks until the operation mode is
selected automatically.
• To cancel this operation, press once more.
■
Remote Control Signal Receiving Sound
• To switch off the beep (Signal Receiving Sound),
press this Auto Operation button for 10 seconds continuously or longer.
“Beep”, “beep” sound will be heard at the tenth seconds.
Note: “Beep” sound will be heard at the fifth seconds;
However please press continuously until you
heard “beep” , “beep” sound.
• Repeat this, if you want to switch on the Signal Receiving Sound.
* Note: If you press this button continuously for 5 to 10 seconds, Test Run
operation will be performed. A “beep” sound will be heard at the fifth seconds,
to identify the starting of Test Run operation.
(This is for Servicing purpose only.)
Auto Restart Control
• If power is resumed after a power failure, the operation will restart
automatically after 3 - 5 1/2 minutes.
• Operation will be automatically restart under the previous operation mode
and airflow direction when power is resumed as the operation is not
stopped by remote control.
Timer Setting
• When power failure occurs, the timer setting is cancelled. Once power is
resumed, reset the timer.
Thunder and Lightning
• This air conditioner is equipped with a built-in surge
protective device. However, in order to further protect
your air conditioner from being damaged by abnormally
strong lightning activity, you may switch off the main
power supply and unplug from power socket.
P
O
W
E
R
EC
O
N
O
M
Y
P
O
W
E
R
FU
L
S
L
E
E
P
T
IM
E
R
POWER FAILURE
55
CS-MA95KE CU-MA185KE / CS-MA125KE CU-MA245KE / CS-MA75KE / CS-MA125KE CU-MA195KE
To Next Page