32 
30 s
Compressor
Outdoor Fan
ON
ON
OFF
OFF
ON
Airflow Direction 
12.3.1 Vertical Airflow 
Cooling
Operating Mode
1             2            3           4          5
 10  ~50  
oo 
Soft dry
Auto
Normal
Powerful
 35  , 6  
o o  
(Begining of POWERFUL mode)
Heating
 12  
o  
Auto
Normal
Powerful
 12  
o  
 10             22                31              40                 50  
oo o o o
 8
oo o o
, 9 , 39  , 41  , 
Auto
Normal
Powerful
 10             22               31              40                50  
oo o o o
 8            24                37             51                  63  
oo o o o
 8
oo o o
, 9 , 35  , 39  , 
 
 
1. Automatic vertical airflow direction can be set using remote control; the vane swings up and down within the angles as stated 
above. For heating mode operation, the angle of the vane depends on the indoor heat exchanger temperature. When the air 
conditioner is stopped using remote control, the vane will shift to close position. 
2. Manual vertical airflow direction can be set using remote control. The angels of the vane are as stated above.  When the air 
conditioner is stopped using remote control, the vane will shift to close position. 
* Above angle data is for reference only. 
12.3.2 Horizontal Airflow 
The horizontal airflow direction louvers can be adjusted manually by hand. 
12.3.3  Quiet operation  
● To provide quiet operation comparing to normal operation. The Quiet operation can be active or stop by pressing 
QUIET/POWERFUL button on remote control.  
● Once Quiet mode is active ,the unit will continuously operate in QUIET Mode until cancel the mode by pressing  
QUIET/POWERFUL button on remote control. 
12.3.4 Powerful operation 
● To cooling or heating the room faster comparing to normal operation. The POWERFUL operation can be active or 
stop by pressing QUIET/POWERFUL button on remote control.  
● When powerful operation is active, the unit will continuously operate in POWERFUL mode until cancel the mode 
by pressing  QUIET/POWERFUL button on remote control. Operation details are as the fig. below. 
 
1.  For cooling, soft Dry mode