8.4.7. Anti-Dew Formation Control
• Purpose is to prevent dew formation on indoor unit air discharge area.
• When room temperature is constant (±1°C) the following conditions occur for 30 minutes continuously, anti-dew formation will
activate:
− Remote Control setting temperature is less than 25°C.
− Compressor is on.
− Cooling operation mode.
− Indoor Fan motor operate at Low fan speed (CLo, Lo- or QLo).
• This control is cancelled immediately when above condition is changed, or Powerful button is pressed.
• Anti-Dew formation is control by:
1. CLo fan is changed to HLo fan.
2. QLo fan is changed to HLo fan.
8.5. Indoor Fan Speed Control
• Indoor Fan Speed can be set using remote control.
8.5.1. Fan Speed Rotation Chart
Fan Speed (rpm) CS-V7DKE CS-V9DKE CS-V12DKE
SHi 1140 1250 1310
Hi 1050 1140 1280
Me 900 940 1080
HLo 850 840 960
CLo 780 750 870
Lo- 750 750 850
SLo 710 710 820
SS Lo - - -
QSHi - - -
QHi 950 1040 1180
QMe 800 840 980
QHLo - - -
QLo 680 650 770
22
CS-V7DKE CU-V7DKE / CS-V9DKE CU-V9DKE / CS-V12DKE CU-V12DKE
To Next Page
Loading...
