40
13.2. Various Setting Mode
13.2.1. Remote Control Number Switch Mode
• Set remote control number through receiving signal from remote control. (Please refer to Select Remote Control Transmission
Code).
13.2.2. Current Setting
• Choose the Current Setting by pressing AUTO OFF/ON button.
13.2.3. Ventilation Control Setting Mode
• Set the ventilation operation and auto filter cleaning operation by pressing Auto OFF/ON Button.
* VENTILATION 1: Enable ventilation operation and auto filter cleaning.
* VENTILATION 2: Disable ventilation operation and auto filter cleaning.
* VENTILATION 3: Ventilation only and no filter cleaning.
• If there is no operation, or receives any remote control signal within 5 minutes, the setting mode quits.
To Next Page
Loading...
