149
Figure 18
19.1.6 To Remove Nanoe™X
Figure 19
19.1.7 To Replace Wireless LAN Module (Network Adapter)
1 Remove the front grille (refer how to take out front grille) from the unit.
2 Remove the indicator piece by releasing the hook.
3 Remove 1 mounting screw, then remove the network adaptor holder.
4 After that, network adaptor can be easily replaced.
Reminder: Serviceman or owner must setting again Panasonic Comfort Cloud app after replace Wireless LAN
Module.
6. Remove Fan Motor.
Reminder: To reinstall the fan motor, adjust
the fan motor connector to 60° towards you
before fixing control board.
3. Unscrew Nanoe
TM
X complete.
Then remove Nanoe
TM
X complete.
1. Remove discharge Grille.
2. Remove CN-NANO
from main electronic
controller.
Indicator
piece
Hook
Screw
Network adaptor
holder
3 42
To Next Page
Loading...
