Panasonic CS-Z35VKR - Auto Restart Control; Indication Panel; Nanoe TMX Operation

100
14.10 Auto Restart Control
 When the power supply is cut off during the operation of air conditioner, the compressor will re-operate within
three to four minutes (there are 10 patterns between 2 minutes 58 seconds and 3 minutes 52 seconds to be
selected randomly) after power supply resumes.
 This type of control is not applicable during ON/OFF Timer setting.
 This control can be omitted by open the circuit of JP1 at indoor unit printed circuit board.
14.11 Indication Panel
LED POWER TIMER iAUTO-X nanoe
TM
X ECO
Color Green Orange Orange Blue Orange
Light ON Operation ON Timer Setting ON iAUTO-X Mode ON nanoe
TM
X ON ECO ON
Light OFF Operation OFF Timer Setting OFF iAUTO-X Mode OFF nanoe
TM
X OFF ECO OFF
Note:
 If POWER LED is blinking, the possible operation of the unit are Hot Start, during Deice operation, operation
mode judgment, or ON timer sampling.
 If Timer LED is blinking, there is an abnormality operation occurs.
14.12 nanoe
TM
X Operation
 Generate nanoe
TM
X (water wrapped ion particle) to moisturize skin, provide deodorization & sterilization effect.
 nanoe
TM
X operation start condition
o During unit running at any operation mode, if nanoe
TM
X operation is activated, combination operation
(operation mode + nanoe
TM
X operation) starts.
o During unit is OFF, if nanoe
TM
X operation is activated, nanoe
TM
X individual operation starts.
 nanoe
TM
X operation stop condition
o When OFF/ON button is pressed to stop the operation.
o When nanoe
TM
X button is pressed.
o When OFF Timer activates.
 nanoe
TM
X operation pause condition
o When indoor fan stop (during deice, odor cut control, thermostat off, etc.). nanoe
TM
X operation resume after
indoor fan restarts.
o When indoor intake temperature  35°C and  5°C. nanoe
TM
X operation resume after indoor intake
temperature < 35°C or  5°C continuously for 6 minutes.
 Indoor fan control
o During any operation mode combines with nanoe
TM
X operation, fan speed follows respective operation
mode. However, nanoe
TM
X system enabled when fan speed  360 rpm to ensure proper negative ion
distribution, nanoe
TM
X system disabled when fan speed < 360 rpm.
o During nanoe
TM
X individual operation, fan speed follow remote control setting. Auto Fan Speed for
nanoe
TM
X individual operation is cooling medium fan. Powerful & Quiet is disabled during nanoe
TM
X.
 Airflow direction control
o During any operation mode combines with nanoe
TM
X operation, airflow direction follows respective operation
mode.
o During nanoe
TM
X individual operation, Air Swing follow remote control setting.
 Timer control
o When ON Timer activates when unit stops, previous operation resumes and restored last saved nanoe
TM
X
operation status.
o When ON Timer activates during any operation, no change on current operation.
o When OFF Timer activates during any operation, all operation stops and the latest nanoe
TM
X operation
status is saved.
 Indicator
o When nanoe
TM
X starts, nanoe
TM
X indicator ON.