144
18.1.1.3 To Remove Electronic Controller
4. Remove control board
cover by releasing 3 hooks.
3 Hooks (Top, left
and right hand side)
Figure 2
9. Detach all connectors as labelled from the
electronic controller. Then pull out the
electronic controller gently.
6. Detach CN-DISP and CN-RCV
connectors from indicator complete.
5. Detach the terminal wire (Black),
terminal wire (Red) and earth wire screws.
7. Remove screw to remove
terminal board complete.
8. Pull out the
electronic
controller halfway.
CN-FM
CN-TH
CN-NANO
AC303 (WHT)
CN-STM1
CN-STM3
CN-STM2
Figure 3 Figure 4
To Next Page
Loading...
