-46-
SCHEMATIC NOTES:
1. RESISTOR
All resistors are carbon 1/4W resistor, unless otherwise noted by the following marks.
Unit of resistance is ohm (Ω), (K=1,000, M=1,000,000)
2. CAPACITOR
All capacitors are ceramic 50V capacitor, unless otherwise noted by the following marks.
Unit of capacitance is µF, unless otherwise noted.
3. COIL
Unit of inductance is µH, unless otherwise noted.
4. VOLTAGE MEASUREMENT
Voltage is measured by a digital meter receiving normal signal.
Note: These schematic diagrams are the latest at the time of printing
and are subject to change without notice.
SERVICE NOTES:
This model has section that does not share a common ground with the power supply section. The different sections
are referred to as HOT section and COLD section in the precautions below.
1. DonottouchtheHOTsectionandtheCOLDsectionatthesametime.Youmayreceiveanelectricshock.
2. Do not short the HOT section to the COLD section. This could blow the fuse or damage parts.
3. NevermeasuretheHOTsectionandtheCOLDsectionatthesametimewhenusingtoolssuchas
oscilloscopes or multimeters.
4. Always unplug the unit before beginning any operation such as removing the chassis.
Chip Transistor Lead Designation
Non Flammable Solid
Metal Oxide Metal (Precision and high stability)
Wire Wound Thermistor
Fusible Positive coefficient Thermistor
Flame Proof Rectangular
Electrolytic Metalized Polyester
Tantalum Polyprolene
Bipolar Mica
Polystyrene Ceramic
Temperature Compensation Ceramic (SL)
Polyester
+
-
m
NP
S
M
CHIP TRANSISTOR
LEAD DESIGNATION
To Next Page
Loading...
