Control Operation
Power Button - Press the POWER button to turn
ON. Press again to turn OFF.
VOL (Volume Buttons)- Press the
VOLUME (VOL) LEFT or RIGHT button for desired
listening level (when On Screen menus are not
displayed). Located On Remote Control
Increases
Volume Level
Decreases
Volume Level
OH (Channel) Buttons
Option 1.
Press the CHANNEL (CH) UP or DOWN button to
sequentially scan through programmed channels
(when On Screen menus are not displayed).
NOTE: TV/CABLE switch (located on Remote) must be
set in TV position (Left).
TVICABLE
Located On Remote Control
Selects Next
herChannel
Selects Next
Lower Channel
Mute Button - Press the MUTE button to quickly
reduce sound level (Mute willappear on screen). Press
again to restore sound.
MUTE
R-Tune (Rapid Tune) Button - Pressthe
R-TUNE (RAPID TUNE) button to instantly switch
between the last two channels selected (without any On
Screen display being activated).
R-TUNE
Q
CHANNEL NOW rr_ CHANNEL TUNED
BEING VIEWED IMMEDIATELY BEFORE
Keyboard "0 through 9" Buttons
Option 2.
Press two digitson the keyboard 0 through 9 buttons
(Example press 0, then 5 for channel 05). For
channels over 99, press three digits on keyboard.
®
oi
Press Button
Press Button Again
d
Helpful Hints:
• Helpful information will display On Screen momen-
tarily when Receiver is first turned on and when the
channel is changed.
• When using keyboard entry for channels 10,11 and
12 in the CABLE mode there is a slight delay before
channel change because of the capability of tuning
cable channels 100 to 125.
NOTE: If no sound is heard from the speakers, press
the TV Speaker button located on back of
i Receiver.
_1 VCR Function Buttons- The VCR
FUNCTION buttons have been designed to operate
numerous brands of VCRs. The infrared code must be
obtained prior to use. (Please refer to Programming the
Universal Remote for programming instructions.)
NOTE: The TV/CABLE switch (located on Remote)
must be in the TV position (Left).
I
7
I REW STOP PLAY FF I
I
I TV/VCR VCRCHANNELPAUSE]
Io®®o',
L .I
-10-
To Next Page
Loading...
