TV/Video Button - Press the I-V/VIDEO button
to select desired input.
TV/VIDEO
Signal connected to:
REAR VIDEO/AUDIO ._
INPUT 1 JACKS
TV or CABLE "_
VIDEO I
CH 02 ._
Multi Button
The MULTI button can be programmed to operate up
to 6 Remote function buttons at the same time.
For Example: TV Power/On, VCR Power/On (selected
brands) can be operated atthe same time withone press
of the MULTI button.
Procedure
1. First program the Remote for the selected VCR
Infrared access code. Confirm that the Remote
Control is compatible with the equipment.
2. Face the Remote Control transmitter away from all
equipment remote sensors.
3. Press and hold down the Remote TV Power button,
then press and hold down the MULTI button at the
same time. Release buttons (All previous com-
mands will be erased.)
Recall Button - Press the RECALL button to
review:
• Audio Mode status
• CH number or Video Input selected
• Sleep Timer status
• Clock time
• Channel Caption (Station Identifier)
RECALL
CH 03
XYYZ
29 1:00
Cable Power Button - TheCABLEPOWER
button on the Remote Control has been designed to
operate selected brands of Cable Television Converter
boxes. The proper cable television converter box
infrared code must be obtained prior to use. (Please
refer to Programming the Universal Remote for
programming instructions.) The Remote Control
TV/CABLE switch should be in the CABLE position.
NOTE: The CHANNEL UP and DOWN buttons on the
Remote may be used for selecting Cable Con-
verter box channels.
CABLE
POWER
Located On Remote Control Q
Use to select Cable Box
Channels after programming
Infrared Code.
(TV)
POWER MULTI
PRESS SIMULTANEOUSLY
4. Press a maximum of 6 Function buttons on the
Remote.
Each button you press is equal to one function. If six
Remote button functions are entered, all will register
in the MULTI button memory in the sequence
entered. When less than six Remote button
functions are entered, press the MULTI button to
end the program mode. (Waiting more than 30
seconds without pressing another button will also
end the program mode.)
The following is an example of Remote functions
that can be programmed into the MULTI button,
- TV Power- For turning TV ON and OFF.
- VCR Power - For turning VCR ON and OFF
(selected brands after programming it's Infrared
access code, if necessary).
Both can be turned ON or OFF with one press of the
MULTI button.
(TV)
POWER VCR POWER
To delete entered functions - Repeat step 3. Now
you can enter from one to six different Remote
functions.
NOTE:
You can also program the MULTI button to perform
most individual Remote Control button functions.
Buttons which continuously perform a function as
long as pressed (Volume Up/Down, Channel
Up/Down, etc.) cannot be programmed. Only those
buttons which perform a function when initially
pressed (Power On/Off, Mute, Direct Channel Entry,
etc.) can be programmed.
-11 -
To Next Page
Loading...
