45
11.2.2.5 Wire Stripping and Connecting Requirement
Cutting and Flaring the Piping
1 Please cut using pipe cutter and then remove the burrs.
2 Remove the burrs by using reamer. If burrs is not removed, gas leakage may be caused. Turn the piping end
down to avoid the metal powder entering the pipe.
3 Please make flare after inserting the flare nut onto the copper pipes.
11.2.3 Outdoor Unit
11.2.3.1 Install the Outdoor Unit
After selecting the best location, start installation to
Indoor/Outdoor Unit Installation Diagram.
1 If installing the unit to a concrete base or other
solid base, use M10 or W3/8 bolts and nuts to
secure the unit, and ensure that the unit is fully
upright and level.
(The anchor bolt positions are shown in the
diagram at the right side.)
In particular, install the unit at a distance from
the neighbouring building which conforms to
regulations specified by local noise emission
regulation standards.
2 Do not install the outdoor unit to the building’s
roof.
3 If there is a possibility that vibration may be
transmitted to the rooms of the building place
rubber insulation between the unit and the
installation surface.
To Next Page
Loading...
