Air Conditioner Service Manual
REMOTE CONTROL INSTRUCTION
Note: Each mode and relevant function will be further specified in following pages.
Remote Control
The remote controller is not presetted as Cooling Only Air Conditioner or Heat Pump by
manufacturer.Each time after the remote controller replace batteries or is energized, the arrowhead
will flashes on the front of Heator Coolon LCD of the remote controller.User can preset the
remote controller type depending on the air conditioner type you have purchased as follows:Press
any button when the arrowhead flashes on the front of Cool , Cooling Only is set.Press any button
when the arrowhead flashes on the front of Heat, Heat Pump is set.If you dont press any button
within 10 seconds, the remote controller is preset as Heat Pump automatically.Note :If the air
conditioner you purchased is a Cooling Only one, but you preset the remote controller as Heat
Pump, it doesnt bring any matter. But if the air conditioner you purchased is a Heat Pump one, and
you preset the remote controller as Cooling Only, then you CAN NOT preset the Heating
operation with the remote controller.
4
To Next Page
Loading...
Need help?
General
