28
CY-VMC7000U
19
E
N
G
L
I
S
H
User Settings (continued)
ID Code setting
Prior to operating this unit, it is advisable to
assign your 4-digit ID code for security.
(Make sure to use four digits for ID code. ID
code can not be set with two or three digits.)
Once the ID code has been set, the unit can-
not be operated if the main power supply is
disconnected then re-connected. It is elec-
tronically locked so that a thief could not use
the stolen unit unless that person knows the
code you have set.
The ID code operation must be performed
only by the person whom the unit belongs to.
Generally, it is not necessary to enter the ID
code each time when using the unit if it has
never been disconnected from the main
power supply (car battery).
USER
ID-CODE
Caution: Record your registered ID code
and keep it in a secure location. If you forget
it, you will be unable to use the unit. In case
that you can not operate the unit because of
forgetting the ID code, please consult your
nearest Panasonic Servicenter.
Select
Select
1 2
Press [MENU] to display the main menu.
q
Press [[] or []] to select "USER".
Press
[}] or [{] to select an item.
w Press [ENTER] to set.
[}] [{]
[]] [[]
(Select)
[ENTER]
[MODE] [MENU]
Note: Refer to ID Code Input regarding how to
enter the ID code. (a page 11)
To Next Page
Loading...
