Panasonic CZ-256ESMC3 - Page 118

ー 116 ー
Operating Instructions Intelligent Controller
140
Conguring the system
Setting
Conguring the system
This chapter describes how to make settings required to run the system. The main settings are as follows:
y Group settings (schedule, area, distribution) y Pulse meter settings, distribution mode settings, distribution ratio settings y Email settings
Screen menu Overview Page Calendr sttngs for distr calc
Set specied days, cut-off days, particular time slots (regular hour ranges) and days of the week for calculating distributions.
148
I/D unit settings
Change the settings on the indoor units. 141
Schedule group name settings
Edit the name of the schedule group. 151
Area group name settings
Edit the name of the area group. 153
Pulse meter settings
Make allocations between pulse meters and distribution groups. 158
Distribution mode settings
Set the mode used for distributing when calculating charges. 160
Distribution Ratio settings
Set the units for calculating electricity and gas usage charges. 161
Event control
Set the conditions for input points and output points to perform linked control. 162
Email settings
Congure the outgoing mail server. 168
O/D unit settings
Change the settings on the outdoor units. 145
Distribution group settings
Edit the name of the distribution group. 155
Communication adapter setting
Register the communication adaptor connected to this unit. 170
141
Conguring the system
Setting
Basic settings on the indoor unit Display details about indoor units (indoor unit addresses, groups belonged to, etc.). Settings can also be changed.
4
Put a check mark in the “Register” column.
z Select the indoor units you want to manage. z This procedure is not necessary if central addresses have
been automatically set. (→ “Automatically setting central addresses” (P.144))
4
5
Touch [Register].
z To cancel the settings, touch [Cancel].
5
1
Touch [System Settings] in “Settings”.
z The “System settings” screen is displayed.
1
2
Touch [I/D unit settings].
z The “I/D unit settings” screen is displayed.
2
3
Check the setting details (P.142).
TGR-318_ENG.indb 116 2017/04/06 10:44:03