Panasonic CZ-RTC5 - Schedule Peak Cut Parameter Settings; Setting Peak Cut Times and Capacity

31
(EN)
8
Set the start time and end time.
Ÿ ź ĺ Ź ĺ Ÿ ź ĺ
(Repeat)
9
Select the operation capacity.
Ÿ ź ĺ
ĺ
(Press 2 times to Þ nish.)
 To set in series
Repeat from step 4 without pressing .
 To change
• Select the Þ eld to change in step 7
above.
• Select [Change].
Ÿ ź ĺ
• Following the above steps 8 to 9,
select the start time, end time and
operation capacity.
 To delete
• Select the Þ eld to delete in step 7
above.
• Select [Delete].
Ÿ ź ĺ
• Select [YES].
Ż Ź ĺ ĺ
(Press 2 times to Þ nish.)