8
(EN)
Basic Operations
1
Start operation.
Press
.
(The operation indicator illuminates.)
To change the setting
(P.10)
To turn the energy saving
operation ON/OFF
Press during operation.
(Only for models equipped with the
energy saving function.)
To stop
(The operation indicator turns off.)
2
Select the item to set.
Press Ż Ź.
3
Change the setting.
Press Ÿź ĺ .
(The cursor disappears.)
Energy saving operation
is in process.
Operation indicator
Note
z Operation modes that cannot be set are not displayed.
z The ß ap display differs from the actual ß ap angle.
z Pressing
after recovery from mains power failure will resume operation with
the contents before mains power failure has occurred.
z If no operation is performed for a certain period of time, the backlight turns off to
save electricity. (Press any button for illumination.)
z The energy saving operation restricts the maximum current value, resulting in
decreased cooling/heating performance.
(If the current of outdoor units does not reach the peak due to low load operation,
the current value is not restricted.)
z The temperature range that can be set varies depending on the model.
z The set temperature range can be changed using the remote controller. (P.26)
z Some models do not display the ß ap.
To Next Page
Loading...
Need help?
General
