3 Press [^ v CH] to select the channel.
2 1,5
HDD, DVD indicator
L2 input termin, _ls
Time Slip
TIME SLIP 3
INPUTSELECT.
buffons
3
II
NAVIGATOR
-- STATUS
_ r_m rm_r_
elt is not possible to record to both HDD (Hard Disk Drive) and DVD
drive simultaneously.
• It is not possibie to record continuously from one side of a double
4
To select with the numbered buttons:
TV Mode (Airwaves) CATV Mode (Cable)
e.g., 5: [O] -- [5] e.g., 5: [0] -- [0] -- [5]
15: [1]..,[5] 15: [0]--[1]m[5]
115: [1]--[1]--[5]
• Select the audio to record (.,* page 17).
Press [REC MODE] to select the
recording mode (XP, SP, LP, or EP).
5
Remaining time { n the disc
=To record sound using LPCM (XP mode only):
Set "Audio for XP Recording" to "LPCM" in the SETUP
menu. (.J page 42)
Press [O REC] to start recording.
Recording will take place on open space on the HDD or on
disc. Data will not be overwritten.
• You cannot change the channel or recording mode during
recording.
• You can record while the unit is on standby for timer recording, but
once the time for the timer recording to begin is reached, any
recording taking place will stop and the timer recording will begin.
• To stop recording
Press[I].
sided disc to the other. You will need to eject the disc and turn it over.
• When using 8 cm (3") DVD-RAM, remove the disc from the cartridge.
• You can record up to 500 titles on HDD, 99 titles on one disc.
• It is not possible to record CPRM (,- page 46) protected material
onto DVD-R or 2.8 GB DVD-RAM discs.
Recorded as 1 title until the position where stopped.
ma'a
When continuously recording for long durations, titles are
automatically divided every 8 hours.
It takes about 30 seconds for the unit to complete recording
management information after recording finishes.
Preparation
Press [RETURN] to exit the television program list if it is displayed on
the television. To turn off auto start up of the television program list
-, page 23, Selecting the TV Guide On Screen system start up
pattern.
I Press [HDD] or [DVD] to select the
recording drive.
The HDD or DVD indicator lights up on the unit.
If you selected the DVD drive
Press [_ OPEN/CLOSE] on the main
unit to open the tray and insert a disc.
• Press tile button again to close the tray.
• If you put a disc in while the HDD is selected, the DVD
indicator on the unit will flash while the unit reads the disc.
Insert fully so it clicks
into place.
• To pause recording
Press [I I].
Press again to restart recording.
(Title is not split into separate titles.)
• To specify a time to stop recording--One Touch
Recording
During recording
Press [O REC] to select the recording time.
Each time you press the button:
0:30 _ 1:00 _ 1:30 _ 2:00 _ 3:00 _ 4:00
¢ Counter (cancel) ( I
• This does not work during timer recordings (,J page 19) or while
using Flexible Recording (,- page 18).
Off Timer
The unit switches to standby after about 6 hours in the stop mode.
You can turn this feature off or change the time to 2 hours
(,- page 40, "Off Timer").
RQT7305
m insert with the arrow facing in.
To Next Page