Refer to the control reference on page 40.
Preparation:
If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below.
When the unit is on and stopped
O Press and hold [v OH] and [^ OH] on the main unit for about five seconds.
The unit turns off.
@ Press [5 DVD POWER] to turn the unit on.
(_ Complete the TV Guide On Screen system setup (until [ENTER] is pressed after the "Watch TV" message screen is displayed).
You can set timer recording only manually after you set the unit with "Auto Channel Setting".
1
2
3
4
Press [SETUP].
Press [&, T] to select "Channel" and
press [1_].
Press [A, _'] to select "Auto Channel
Setting" and press [ENTER].
*The unit configures channels according to the Antenna
System settings as follows.
Antenna system Band Channel
VHF 2-13
TV
UHF 14-69
VHF 2-13
CATV LOW BAND 95-99
CATV MID/SUPER BAND 14-36
Press [4, I_] to select "Yes" and CATV CATVHYPERBAND 37-65 u_
66-94 _;
press [ENTER]. ULTRA BAND 100-125 "_
"6
5 Press [ENTER]. SPECIAL CATV CHANNEL 1
Auto Channel Setting starts. This takes a few minutes.
The unit then proceeds with Auto Clock Setting. The time is ._
displayed when finished.
6
*DST, Daylight Saving Time, shows the summertime setting.
*TIME ZONE shows the time difference from Greenwich
meantime (GMT).
EST (Eastern Standard Time) = GMT 5
CST (Central Standard Time) = GMT 6
MST (Mountain Standard Time) = GMT 7
PST (Pacific Standard Time) = GMT 8
AST (Alaska Standard Time) = GMT 9
HST (Hawaii Standard Time) = GMT 10
For other areas: xx hr
• If the Auto Clock Setting does not start automatically, select
"Auto Clock Setting" from the "Set Up" tab.
• If the time was not set correctly, use manual clock setting
(,,, page 11) or time zone adjust.
Press [ENTER].
I Time Zone Adjust
Adjustthetimezone( 1 or +l) if it was not set correctly with auto
clock setting.
You cannot change this setting if you set the clock manually.
1 Press [SETUP].
2 Press [&, T] to select "Set Up" and
press [1_1.
3 Press [A, T] to select "Time Zone
Adjust" and press [ENTER].
4 Press [&, _'] to select "-1" or "+1"
and press [ENTER].
To exit the screen
Press [SETUP].
To return to the previous screen
Press [RETURN].
RQT7305
To Next Page
Loading...
