Panasonic DMC-FT2 - Inserting and Removing Card;Battery

VQT2M46 (ENG)
22
Inserting and Removing the Card
(optional)/the Battery
• Check that this unit is turned off.
• Confirm that there is no foreign object.
• We recommend using a Panasonic card.
1:Slide the [LOCK] switch B, and
release the lock.
2:Slide the release lever A and
open the card/battery door.
• Always use genuine Panasonic batteries
(DMW-BCF10E).
• If you use other batteries, we cannot
guarantee the quality of this product.
Battery: Insert until it is locked by
the lever C being careful about the
direction you insert it. Pull the
lever C in the direction of the
arrow to remove the battery.
Card: Push it fully until it clicks
being careful about the direction
you insert it. To remove the card,
push the card until it clicks, then
pull the card out upright.
D: Do not touch the connection terminals of the card.
•
The card may be damaged if it is not fully inserted.
Close the card/battery door until it
clicks, and then lock the [LOCK]
switch by sliding it toward [2].
DMC-FT2&TS2GN-VQT2M46_eng.book 22 ページ ２０１０年２月９日 火曜日 午前８時４６分