130
Recording
You can separately control flash-firings of the built-in flash and each flash in three groups
by using the flash that supports the wireless control (DMW-FL360L: optional).
1
Configure the external flash setting to RC mode, and then place the external flash.
• Set the channel and group of the external flash.
2 Select [Flash] on the [Rec] menu. (P37)
3 Press 3/4 to select [Wireless Channel], [Wireless FP], [Communication Light]
or [Wireless Setup] and then press [MENU/SET].
4 Press 3/4 to select the item and then press [MENU/SET].
[Wireless Channel]
Select the channel that corresponds to the channel of the external flash you want to
control.
Settings: [1CH]/[2CH]/[3CH]/[4CH]
[Wireless FP]
During wireless recording, an external flash fires an FP flash (high speed repetition of flash
firing). This firing allows recording with the flash at a fast shutter speed.
Settings: [ON]/[OFF]
[Communication Light]
Set the communication light level of the built-in flash for wireless recording.
Settings: [HIGH]/[STANDARD]/[LOW]
Setting the wireless flash (When [WIRELESS] is selected)
Preparations: Open the flash of this unit by pressing flash open button.
To Next Page
Loading...
