2 Check Firmware Version
CAUTION: If the player has the most recent firmware, there is no need to perform
a firmware update.
1) Press the [POWER] button on the player to turn it ON.
2) Press the [SETUP] button on the remote control to display the player’s MENU.
3) Using the [UP ARROW] or [DOWN ARROW] on the remote control, highlight
DISPLAY and then press [OK].
4) Press the [STATUS] button on the remote control to display the current firmware
version in the lower right corner of the DISPLAY screen.
CAUTION: Compare the current firmware version displayed to the firmware
version received or downloaded. If they are the same, or the firmware version
displayed in the player is higher, there is no need to install the firmware.
Reasons why the player may have a more recent firmware version:
• If the player was manufactured after the firmware was released, the firmware
update may have already been installed.
• If the player was serviced by an authorized Panasonic service center, a service
technician may have already installed the latest firmware update.
DMP-BD30 Blu-Ray Disc Player Firmware Installation Instructions
Page 3 of 8
To Next Page
Loading...
