73
Self-diagnosis
The self-diagnosis displays appear if a problem occurs with the unit.
The service numbers in the table appear when a problem occurs.
≥The service numbers are a “U” followed by two digits.
Service
number
Unit status Solutions
NO READ The disc is dirty or badly
scratched.
≥Follow the instructions in “Maintenance and Handling” to clean the disc if it is dirty.
(page 70)
≥The disc cannot be played if it is scratched and this display doesn’t disappear.
It can not be read for the disk
which doesn’t cope with it.
≥It can not be read for the disk which doesn’t cope with it. Exchange a disk.
The DVD-RAM/PD lens
cleaner has finished cleaning.
≥Take the cleaner out of the unit.
UNSUPPORT
You have inserted a disc the
unit cannot play or record on.
≥Insert a disc the unit can play or record on. (page 10)
U14 The unit is hot. ≥The unit switches to standby automatically for safety reasons and you cannot operate
it. Wait for about 30 minutes for the service number to disappear.
≥Select a position with good ventilation when installing the unit.
≥Do not block the cooling fan on the rear of the unit.
U99 The unit fails to operate
properly.
≥Press [Í/I] to switch the unit to standby. Now press [Í/I] again to turn the unit on.
REMOTE
DVD
The remote control code is
wrong.
≥Change to the correct code. (page 65)
RECOVER A power failure occurred or the
AC mains plug was
disconnected while the power
was ON.
≥The unit is carrying out its recovery process. Wait until the message disappears.
B.book 73 ページ ２００３年５月２日 金曜日 午前１０時８分
To Next Page
Loading...
