9.2. (VHS) Removal by manual operation by rotating the Loading
Motor with the batteries.
1. Disconnect the AC plug, and remove the Top Panel and the Front
Panel by referring to the Disassembly Procedures.
2. Connect three batteries (1.5V spec.) to the Loading Motor in series
for supplying 4.5V to rotate the Loading Motor as shown below.
3. Stop unloading just before unloading will be completed as shown
below, and then the tape becomes slack as shown below.
4. Rotate the S-Reel by a small minus screwdriver to remove the
slack tape as shown below.
13
To Next Page
Loading...
