Panasonic DMR-E75VP - 13.13. Power & Digital I;F P.C.B.

CAUTION 1:
When replacing Digital P.C.B., pay attention to inserting FFC, and be
careful to do not touch surface of CSP ICs.
If you have touched surface of CSP IC, clean up with alcohol and so
on to prevent oxidation.
CAUTION 1:
When attaching Digital P.C.B. on to Earth Angle, Earth Angle should
be touches to DVD angle as shown below.
13.13. Power & Digital I/F P.C.B.
1. Remove Front Panel (refer to 13.5.), Rear Panel (refer to 13.7.), DVD
-RAM Drive (refer to 13.11.),Digital P.C.B.
(refer to 13.12.) and VTR Mechanism (refer to 13.9.).
2. Disconnect 4 Connectors.
3. Install VTR Mechanism (refer to 13.9.).
49