STOP, and OPEN / CLOSE simultaneously for five seconds.
- Process mode 1 setting: While the power is off, press SKIP(R),
TIME SLIP, and OPEN / CLOSE simultaneously for five
seconds.
2. For disassembly and replacement procedures, refer to the
“Assembling and Disassemling”.
6.1. Service Explorer Express
The following steps allow you to check each block separately (HDD, UART P.C.B., Digital P.C.B.,
RAM drive, Main / Power Supply / Front P.C.B.).
Items needed: RAM drive, Digital P.C.B., Digital extension cable, Remote control HDD, UART
P.C.B..
Conditions: Nothing special.
9
To Next Page
Loading...
