12
RQT7458
Getting started
Refer to the control reference on page 11.
STEP
2
Channel reception settings
≥When connecting to a television with the VIDEO OUT,
S-VIDEO OUT or COMPONENT VIDEO OUT terminal
(➡ page 8).
≥When connecting to a television that does not have
the Q Link function (➡ page 49).
This unit’s Auto-Setup function automatically tunes all available TV
stations and synchronizes the time when the TV channel that is
broadcasting time and date information is tuned.
≥When connecting to a television with RF socket only
(➡ page 9)
1 Turn on the television and select the
appropriate AV input to suit the
connections to this unit.
2 Press [Í DVD] to turn the unit on.
Auto-Setup starts. This takes about 5 minutes.
(When connecting to a television with RF socket only)
Set the new RF output channel to TV (refer to the
instructions for your TV).
Select an unused channel pre-set on your TV and tune it to
the RF output channel number shown on the unit’s display.
(When the Auto-Setup screen does not appear clearly even
after performing the above operations, re-tune the channel
until the Auto-Setup screen becomes clear.)
3 When Auto-Setup has completed, the Owner ID settings
screen appears.
Press [1] and press the numbered
buttons to enter a 4-digit PIN number.
≥Make a note of the PIN number (don’t forget), as it is not
possible to return to the factory preset.
4 Press [ENTER] twice to store the PIN
number.
The cursor moves to “Name”.
5 Press [1].
6 Press [3, 4] to select a letter and
then press [1].
Repeat this to enter the name.
7 Press [ENTER] to store the name.
8 Press [4] and [1], and then repeat
steps 6, 7 to enter and store “House
No.” and “Postcode”.
9 Press [RETURN].
The Owner ID settings screen disappears.
To stop partway
Press [RETURN].
∫ If the clock setting menu appears
Set the clock manually (➡ page 46).
∫ To confirm that stations have been tuned
correctly (➡ page 44)
∫ To restart Auto-Setup (➡ page 45)
You can also use the following method to restart Auto-Setup.
When the unit is on and stopped
Press and hold [X CH] and [CH W] on the main unit for about 5
seconds.
≥All the settings except for the ratings level, ratings password,
Owner ID and time settings return to the factory preset. The timer
recording programmes are also cancelled.
[When connecting to a television with RF socket only (➡ page 9)]
∫ To enter the satellite station’s name (➡ page 44)
The name of the satellite station is not set automatically. (“-- ---” will
appear under “Name” in the program list). After Auto-Setup is
completed, enter the name manually.
∫ If you connect other equipment to AV2 terminal
of this unit
Change the “AV2 Input” and “AV2 Connection” in the SETUP menu
to match the connected equipment (➡ page 43).
Auto-Setup
(Setup without Q Link functions)
Auto-Setup
Ch 1
Auto-Setup in progress, please wait.
RETURN: to abort
RETURN
RETURN
Owner ID
RETURN : leave
PIN number
¢¢¢¢
Name
House No.
Postcode
7458en.book12ページ２００４年５月１４日 金曜日 午前１０時４７分
To Next Page
Loading...
