to turn the unit on.
–
“HELLO” appears on the unit’s display.
to select the drive (DVD or VHS).
Insert a disc or VHS cassette.
– Insert a disc or VHS cassette with enough remaining blank space
( 13).
When the set top box is controlled with this unit:
to select desired channel.
or
When the set top box is not controlled with this unit:
to select “IN1” or “IN2”.
– Select a channel on the connected equipment
to select the recording mode.
– Recording mode should be determined by program length and
available time on selected media ( 22)
Recording mode
Remaining time
to start recording.
Recording Set Top Box Programs
Preparation:
Turn on the television and select the appropriate video input to suit the
connections to this unit (example: AV input, etc.).
When using the set top box, make sure it is turned on.
[RAM] If the disc is protected, release protection ( 47).
[VHS] Ensure accidental erasure tab is intact.
Pausing Recording
Press [ PAUSE].
– Press again to restart recording.
Stopping Recording
Press [ STOP].
Refer to “Important Notes for Recording” ( 21) and “Advanced Recording”
( 22–24) for detailed information on recording.
[RAM] [-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW] [VHS]
Tips
Icons such as “ [RAM] ” indicate usable
discs. Refer to pages 66 and 67.
Notes
[-R] [-R]DL] [-RW‹V›] [+R] [+R]DL] [+RW]
It takes about 30 seconds for the unit
to complete recording management
information after recording fi nishes.
You cannot change the channel or
recording mode during recording.
Simultaneous recording to both DVD
and VHS is not possible.
DMR-EA38VP.indb16DMR-EA38VP.indb16 2007/12/289:25:222007/12/289:25:22
Downloaded From DvDPlayer-Manual.com Panasonic Manuals