Getting started
SQT0816
12
Control reference guide
• While writing to/reading from the media, do not switch the
unit to standby mode or remove the media. Such action
may result in loss of the media contents.
• When inserting the media, ensure that it is facing the right
way up.
Main unit
1 Remote control signal sensor
• Angle: Approx. 20° up and down, 30° left and
right
• Distance: Within approx. 7 m in front of the
unit
2 Start play
3 Standby/on switch (Í/I)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the unit
is still consuming a small amount of power.
4 USB port
Pull to flip down
the front panel.
Display
USB memory
Display
1 Drive (HDD) indicator
2 Copying indicator
3 USB port indicator
4 Remote control signal indicator
5 Timer recording indicator
This indicator lights up when the timer
recording standby is activated.
6 Main display section indicator
- Current time
- Playback counter
- Various messages (> 83), etc.
7 Playback indicator
8 Recording indicator
• The indicator will light up while recording.
• The indicator will blink while recording is
paused and before recording starts.
PLAY
COPY
USB
HDD
14532
678
DMRHWT250GL_eng.book 12 ページ ２０１５年２月４日 水曜日 午後４時３４分
To Next Page
Loading...
