Troubleshooting
SQT0816
79
3D video is not output correctly.
• 3D video may be output correctly by changing
the following settings:
- “3D Type” of “3D Settings” (> 62, 68)
- “Signal Format” (> 39, 3D settings during
playback)
• Check the settings of the connected TV.
• When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video
is not output. (> 14)
• When the amplifier/receiver which is connected
between this unit and a TV is off, 3D video is not
output. (> 14)
• When “HDMI Audio Output” is set to “Off”, 3D
video may not be output correctly. (> 69)
No sound.
Distorted sound.
• Check the connections. (> 13)
• Check the settings of the connected TV, etc.
• Press [AUDIO] to select the audio. (> 23, 38)
• To output audio from a device connected with an
HDMI cable, set “HDMI Audio Output” to “On”.
(> 62, 69)
Cannot change audio channel.
• You cannot change the audio channel if “Digital
Audio Output” is set to “Bitstream”. (> 67)
The same video is displayed in each left and
right half of the screen.
• This is a 3D programme of the Side-by-Side
type.
Change the setting as follows if connecting with
a 3D compatible TV:
1Press [DISPLAY].
2 Select “3D Settings”, then press [OK].
3 Select “Side by side” in “Signal Format”, then
press [OK].
Sound
DMRHWT250GL_eng.book 79 ページ ２０１５年２月４日 水曜日 午後４時３４分
To Next Page
Loading...
