Panasonic DMR-XS350

Programme details and times
may be available via specialist
satellite magazines or on the
internet.
There is no EPG data
broadcast with the
programmes. Only the channel
names will appear when the
”GUIDE” button is pressed
I do not receive a
programme guide when
viewing “Other Satellite”
channels.
Please see the detailed
instructions “Setting up Other
Sat Reception” (page 13). It will
take about 45 minutes to scan
for all “Other Satellite”
broadcasts available. Once set
up, use the “Input Select” button
to select “Other Sat”.
Before “Other Satellite”
channels can be selected, the
channels must be set up using
“Other Satellite Auto Setup”.
I can not receive “Other
Satellite” broadcasts.
To toggle between the
recordings, use the channel
up/down buttons. The recording
which is actively being
controlled will be displayed on
the screen. Pressing the
“STOP” button will prompt you
to confirm the recording that
you intend to stop. If this is
incorrect select “No” and toggle
to the second recording, before
pressing the “STOP” button
again (page 23).
With two tuners it is possible to
have two recordings running at
once. If you press the “Stop”
button it will stop the recording
on the current channel.
When I have two
recordings taking place at
the same time, how can I
stop the first recording
while leaving the second
recording running?
There are restrictions to how
many times the HD recoding
can be copied. The number of
copies possible can be checked
by looking at the number on the
copy flag for the desired
recording in the navigator
window. It is still possible to
make a standard definition copy
onto DVD.
The recording may not allow
copies to be made depending
on the copy flag sent by the
broadcaster at the time of
transmission.
I can not copy an HD
recording from the HDD to
the BD Drive.
Once the recording has been
made on the HDD, it can be
copied onto BD/DVD drive.
There are restrictions to how
many times some HD
recordings can be copied. The
number of copies possible can
be checked by looking at the
number on the copy flag for the
desired recording in the Direct
Navigator (page 49).
All recording are made to the
hard disc drive (HDD). This is
necessary for the unit to
comply with the copyright
protection specification for high
definition recorders.
I can not set a timer
recording or manually
record to the BD/DVD
Drive.
RemedyPossible CauseProblem
Page 57
Troubleshooting Guide