6. Fax
43
make sure that feature #401 is activated (page 62). For
an explanation of the messages, see page 81.
Printing a journal report
A journal report provides you with a printed record of the
30 most recent faxes. To print it manually, see page 103.
To print it automatically after every 30 new fax
transmissions and receptions, make sure feature #402 is
activated (page 62). For an explanation of the
messages, see page 81.
6.1.2 Using the automatic document feeder
1
If the {Fax} light is OFF, turn it ON by pressing
{Fax}.
2 Set the original (page 20).
3 If necessary, change the resolution and contrast
according to the type of document.
L To select the resolution, see page 42.
L To select the contrast, see page 42.
4 {Monitor}
5 Dial the fax number. i {Start}
Note:
L To stop sending, see page 78.
L Do not open the document cover when sending a fax
with the automatic document feeder.
Pre-dialing a fax number
1. Enter the fax number.
2. Set the original (page 20). i {Start}
Sending from memory (Quick scan feature)
1. Set the original (page 20).
2. Enter the fax number.
3. Press {V} or {^} repeatedly to select “Quick
Scan”, then press {<} or {>} repeatedly to select
“On”. i {Start}
To send 2-sided originals
1. Set the original (page 20).
2. {Duplex}
3. Press {V} or {^} repeatedly to select the desired
binding of the original.
– “Long Edge”
– “Short Edge”
4. {Set}
5. Dial the fax number. i {Start}
{Monitor}
{Start}{Fax}{Set}{V}{^}{<}{>}
{Duplex}
To Next Page
Loading...
