9. Programmable Features
60
Setting the recording paper
type
{#}{3}{8}{3}
{1} “Plain Paper” (default): 75 g/m
2
to 90 g/m
2
(20 lb to 24 lb) paper.
{2} “Thin Paper”: 64 g/m
2
to 75 g/m
2
(17 lb to 20 lb) paper.
{3} “Thick Paper”: 90 g/m
2
to 165 g/m
2
(24 lb to 44 lb) paper.
Note:
L This setting is valid for both the standard input tray and the lower input tray.
L “Thick Paper” will not be displayed if any of the paper input tray settings
are changed to “#2” or “#1+#2”:
– fax (feature #440 on page 64).
– copy (feature #460 on page 67).
–PCL
®
(feature #760 on page 69).
– scan to email print feature (feature #565 on page 74).
Setting the paper input tray to
use for lists and reports
printing
{#}{3}{9}{0}
This feature will be displayed only when the lower input tray is installed (page
79).
{1} “#1” (default): Standard input tray
{2} “#2”: Lower input tray
{3} “#1+#2”
Note:
L To select “#2”, select “Plain Paper” or “Thin Paper” for the recording
paper type setting (feature #383 on page 60).
L To select “#1+#2”,
– select the same paper size for the standard input tray (feature #380 on
page 59) and lower input tray (feature #382 on page 59). If either is
changed, “#1” will be selected automatically.
–select “Plain Paper” or “Thin Paper” for the recording paper type
setting (feature #383 on page 60).
Setting the waiting time for
the power save mode
{#}{4}{0}{3}
To set the length of time before the unit enters power save mode.
{1} “5min”: 5 minutes
{2} “15min” (default): 15 minutes
{3} “30min”: 30 minutes
{4} “1h”: 1 hour
Note:
L When in power save mode, the unit needs to preheat the fuser unit before
it can begin printing.
Holding the previous contrast
setting
{#}{4}{6}{2}
{0} “Disabled” (default): Deactivates this feature.
{1} “Enabled”: The unit will hold the previous setting.
Note:
L The previous setting will be held individually for copying and sending faxes.
Setting the default operation
mode
{#}{4}{6}{3}
To select the default operation mode when the selected time of the mode timer
(feature #464) passes.
{1} “Copy” (default): Copy mode is selected as default.
{2} “Fax”: Fax mode is selected as default.
Note:
L You cannot select the scan mode using this feature.
Setting the default operation
mode timer
{#}{4}{6}{4}
To set the timer before returning to the default operation mode (feature #463).
{0} “Off”: Deactivates this feature.
{1} “30s”: 30 seconds
{2} “1min” (default): 1 minute
{3} “2min”: 2 minutes
{4} “5min”: 5 minutes
Feature/Code Selection
To Next Page
Loading...
