9. Programmable Features
68
Setting the paper input tray
prompt for copy
{#}{4}{7}{1}
This feature will be displayed only when the lower input tray is installed (page
79).
{0} “Off”: Deactivates this feature.
{1} “Auto” (default): When making a copy, you will be prompted to select the
desired paper input tray if the recording paper size setting is different for the
standard input tray (feature #380 on page 59) and the lower input tray (feature
#382 on page 59).
{2} “Always”: When making a copy, you will always be prompted to select the
desired paper input tray.
Note:
L When prompted, select the desired paper input tray by pressing {<} or {>}
repeatedly, then press {Start}.
L Even if “Auto” or “Always” is selected, this feature will not be activated if
the recording paper type setting (feature #383 on page 60) is set to “Thick
Paper”. Change the setting to “Plain Paper” or “Thin Paper”
beforehand.
Feature/Code Selection
To Next Page
Loading...
