Panasonic DVD-A7

Purpose : To maintain video signal output compatibility.
1. Connect the oscilloscope to the video component output terminal
and terminate at 75 ohms.
2. Apply the trigger at the Y output terminal signal.
3. Adjust VR3201 so that the video component signal (CB) level
becomes 525 mVp-p ±11 mV.
13. Abbreviations
INITIAL/LOGO ABBREVIATIONS
A
A0~UP
ACLK
AD0~UP
ADATA
ALE
AMUTE
AREQ
ARF
ASI
ASO
ASYNC
ADDRESS
AUDIO CLOCK
ADDRESS BUS
AUDIO PES PACKET DATA
ADDRESS LATCH ENABLE
AUDIO MUTE
AUDIO PES PACKET REQUEST
AUDIO RF
SERVO AMP INVERTED INPUT
SERVO AMPOUTPUT
AUDIO WORD DISTINCTION
SYNC
B
BCK
BCKIN
BDO
BLKCK
BOTTOM
BYP
BYTCK
BIT CLOCK (PCM)
BIT CLOCK INPUT
BLACK DROP OUT
SUB CODE BLOCK CLOCK
CAP. FOR BOTTOM HOLD
BYPATH
BYTE CLOCK
40