EasyManua.ls Logo

Panasonic DVD-RV65

Panasonic DVD-RV65
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
lo.l
_ICAL
Beck of the unit
Note when connecting the optical digital audio cable
Dust protection cap thgtethrrri:_Vgwith
oRemove the dust protection cap from the optical digital audio
output terminal and connect the cable firmly so that the configu-
rations of both the cable and the terminal match.
eKeep the dust protection cap and reattach when not using the
terminal.
Optical digital audio cable
eDo not bend the optical digital audio cable when connecting it.
Coaxial audio cable
System component or amplifier with digital audio input
terminals and speakers
eRead the instructions for the amplifier and speakers or system
component for connection details.
When you have finished connection
Make changes to "7 Digital Audio Output" as shown (m page 36).
PCM Down Conversion Yes _
Dolby Digital PCM
DTS Digital Surroun Off
If this is set to "No", no audio will be output when DVDs recorded in
96 kHz linear PCM are played. (Audio will be output as it is if the
DVD does not have copyright protection recorded on it.)
eThese changes to digital audio output must be made,
otherwise signals the equipment cannot handle, bitstream, will
be output. It the signals are output as bitstreem, "noise" will be
output which can cause harm to your ears and speakers.
II
You can enjoy stereo sound if you connect an amplifier or system component that has 2-channel audio input terminals.
Audio cable
[] @1@,@1@
Back of the unit
Amplifier and speakers or system component
Read the instructions for the amplifier and speakers or
system component for connection details.
To enjoy Dolby Pro Logic
lit you connect an amplifier with Dolby Pro Logic
decoder, you will also need to connect center and
surround speakers to enjoy surround sound. Read the
instructions for the equipment for connection details.
eTurn V.S.S. off (m page 22). Dolby Pro Logic decoder
will not function correctly if V.S.S. is on.
When you have finished connection
eGo to "7 Digital Audio Output" and set "1 PCM Down Conversion" to
"No" (-_ page 36).
*In "8 Speaker Setting', select "2 2-channer' (-, page 38).
eUse the connection described in [] on page 34 to enjoy DVDs
encoded with DTS.

Related product manuals