DISASSEMBLY / REASSEMBLY INSTRUCTIONS
MCUK000601C8 Section 4 Issue 1
Service Manual – 21 – Revision 0
Figure 4.5: GD52 PCB Assembly Removal
4.2.2 Case Removal (GD92 / GD92C)
1. Remove the battery from the back of the telephone. Remove the four case screws located inside the battery compartment.
Figure 4.6: GD92 / GD92C Screw Removal
2. Remove the cover from the case by pulling from the connector end of the telephone. Care must be taken when separating
the case from the cover as the retaining clips may be very stiff. If necessary, re-attach the battery to provide extra support
for the case.
Figure 4.7: GD92 / GD92C Case-Cover Separation
3. Remove the PCB assembly from the cover.
10194-1
10192-1
10193-1
To Next Page
Loading...
