DISASSEMBLY / REASSEMBLY INSTRUCTIONS
PMCD030901C8 Section 6 Issue 1
Service Manual – 31 – Revision 0
7. Undo the two screws securing the hinge strap. Retain the screws.
8. Slide the hinge strap forwards (towards the upper case unit) to remove it, taking care not to damage the board to board
flexi-strip.
9. Gently twist the upper case assembly to lift the Main PCB away from the lower case back. Separate the PCB from the
upper case assembly by disconnecting the ribbon cable from connector CN200.
6.2.2. Upper case assembly and display module removal
1. Using tweezers or a pin, remove the two grey screw caps and discard. Remove the Escutcheon and discard.
2. Use the trident screwdriver to remove the four screws. Retain the screws for re-assembly.
10718-1
10719-1
CN200
10723-1
To Next Page
Loading...
