DISASSEMBLY / REASSEMBLY INSTRUCTIONS
PMCD030901C8 Section 6 Issue 1
Service Manual – 35 – Revision 0
6.2.8 Microphone removal
1. Lift the microphone insert from its recess in the handset lower case.
6.3. Reassembly
6.3.1 Display module reassembly
1. Ensure that the earth contact is attached to the LCD chassis.
2. Fit the Main LCD assembly onto the LCD chassis, feeding the sub-LCD flexi-strip through the central hole of the chassis.
3. Fit the white insulator (C) to the chassis (B) by first sliding it under the sub-LCD flexi-strip (A) then locating it over the two
white posts.
CAUTION
IF ANY OF THE RF, BLUETOOTH OR BASEBAND SHIELDS ARE REMOVED FROM THE PCB AT ANY TIME, THEY
MUST BE REPLACED BY NEW ITEMS. ONCE REMOVED, THE SHIELDS MUST NOT BE REUSED.
NOTES: If the case assemblies have been disassembled and reassembled more than three times, they should be
replaced with new items.
Examine all case and cover parts before reassembly. If any scratches or defects are found in their finish,
they should be replaced by new items.
10739-1
10754-1
10753-1
C
A
B
To Next Page
Loading...
