DISASSEMBLY / REASSEMBLY INSTRUCTIONS
Issue 1 Section 6 PMCD030901C8
Revision 0 – 36 – Service Manual
4. Fit the display PCB by first sliding it under the sub-LCD flexi-strip and then locating over the two white posts.
5. Locate the end of the sub-LCD flexi-strip (C) into its connector on the display PCB and lock in place.
6. Refit the camera to the LCD chassis.
7. Reconnect the flexi-strips (A and B) to the PCB, taking care not to damage the receiver connector flexi-strip (D).
6.3.2 Upper case reassembly
1. Hold the display PCB at approximately 90° to the case front and locate the board-to-board flexi-strip in the slot in the central
hinge.
2. Locate the display PCB inside the case front.
3. Fit the receiver inside the case front.
4. While holding the receiver in place, locate the back of the receiver connector into the corresponding slots in the case front
and then press on the connector until it locks into position.
5. Snap the upper case back over the upper cover front. Fit the four screws saved during disassembly, and tighten to 1.3kgf.
6. Fit two new screw covers over the two upper screws and a new escutcheon / nameplate over the two lower screws.
6.3.3. Vibrate motor and DTHF speaker
1. Locate the speaker (wire end first) into the holder and snap into position at the point marked ‘A’.
2. Route the speaker round the cable management pins as shown.
A
B
C
D
10755-1
10723-1
To Next Page
Loading...
