Assembly
EN13
▶
Continued on the next page
ㅡ
Arm massage will not operate unless the air
plugs are inserted securely.
②
Insert the left side in the same way.
Air plug
Protrusion
Air plug jack
<View from bottom>
Press until the protrusion
clicks into place.
3
Inserting the air plug
①
Insert the air plug into the air plug jack
on the armrest with your fingers until it
clicks into position.
4
Attaching the controller to
the controller holder
①
Insert the controller
at an angle to
the bottom of the
controller holder.
Protrusions
Cavities
②
Insert the controller
until the two
protrusions on the
controller holder
click into the cavities
on both sides of the
controller.
Lift up the controller
to remove.
●
Fasten the controller cord using the cord clip.
Fasten so the cable under the
cord clip
will not sag too
much (because of the risk of tripping over the cord).
Cord clip
Controller
cord
To Next Page
Loading...
