●
Tighten the 4 screws
lightly using your fingers.
(Make the screws level
with the holes.)
●
Tighten firmly with the
allen key.
●
Screw may be damaged
if you tighten the screw
inserted into the hole
crookedly using an allen
key.
EN12
2
Fasten the armrest
①
Insert the armrest into the unit.
ㅡ
“
R
” (right side) and “
L
” (left side) are indicated at the
back of the armrest.
ㅡ
Insert the armrest from the top aligning the
▲
marks
on the side of the armrest.
ㅡ
Be careful to avoid pinching your fingers and air
plugs.
②
Slide the armrest toward the back while
pushing it downward.
③
Fasten the armrest with the attachment
screws.
(One for each side)
ㅡ
Use this screw
Attachment screws (M6 × 29) × 2 pcs. (Silver)
Assembly
②
Fasten the controller stand with the
attachment screws (4 positions)
ㅡ
Use this screw
Attachment screws (M6 × 13) × 4 pcs.
(Black)
■
How to tighten the screws
If the controller stand is attached on the left hand side, pass the controller cord through the left hand side. (Page EN15)
<Attaching the right armrest>
1
Attaching the controller stand
The controller stand can be attached on either the left or right side.
<When attaching on the right armrest>
①
Align the 2 prongs of the side panel with the holes of the controller stand.
Attachment screw
Hole
Allen key
Controller stand
■
How to tighten the screws
Allen key
●
Put an attachment screw on the
edge of the allen key and tighten
the screw horizontally to the hole.
●
Screw may be damaged if you
tighten the screw inserted into the
hole crookedly using an allen key.
Align the
▲
marks.
Front
①
④
Attach the left hand side in the same way.
●②
●③
To Next Page
Loading...
