Assembly
EN15
■
When the controller stand is attached on the left side
●
Run the controller cord to the left such as the right side of figure.
●
The product is shipped with the controller cord fastened to the right side.
①
Press on the controller.
②
Press and hold on the controller
until a beep-beep-beep sound is heard.
ㅡ
The legrest will rise until it reaches the
uppermost position.
③
Disconnect the controller cord.
ㅡ
Hook is released by pressing on the tab on the fastening band with your fingers.
④
Move the controller cord under the legrest to the left side.
Fasten to the right sideFastening band
Tab
Controller cord
Controller cord
Cord-holder groove
④
⑥
⑤
Legrest
②
③
③
⑤
Fasten the controller cord.
ㅡ
Press down from the edge if it does not fit in easily.
⑥
Insert the tip of the fastening band into the hole.
View from front
To Next Page
Loading...
