Panasonic ES-LL21 - Preparation; Charging the Shaver

11
English
Abnormal charging
The charge status lamp ( ) will blink twice every second.
Notes
• After charging is completed, turning the power switch ON
with the shaver plugged in will cause the charge status lamp
(
) to light up and then turn off after 5 seconds.
This shows that the shaver is fully charged.
• When charging the shaver for the rst time or when it has
not been in use for more than 6 months, the charging time
may change or the charge status lamp ( ) may not glow for
a few minutes. It will eventually glow if kept connected.
• Recommended ambient temperature for charging is
10 – 35 °C (50 – 95 °F). It may take longer to charge, or the
charge status lamp ( ) will blink quickly and the battery may
fail to charge properly in extremely high or low temperatures.
• The shaver can be used for approximately 2 weeks with a
full charge.
(Based on one 3-minute dry-shave usages per day in an
ambient temperature range of 20 – 30 °C (68 – 86 °F).)
The number of usable days varies depending on the
following conditions.
- Beard thickness
- Pressure applied to the skin
- Usage frequency of the sonic vibration cleaning mode
- Use of the trimmer attachment
• If there is noise from the radio or other sources while using
or charging the appliance, move to a different location to use
the appliance.
Preparation
Charging the shaver
• Turn the shaver off.
• Wipe off any water droplets on the appliance socket.
1. Insert the appliance plug into
appliance socket.
2. Plug the adaptor into a
household outlet.
• Check that the charge status lamp
( ) is glowing.
• Charging is completed after
approx. 1 hour.
3. Disconnect the adaptor after
charging is completed.
1
2
Note
You cannot operate the shaver while charging.
While charging
The charge status lamp ( )
glows.
After charging is completed
The charge status lamp ( )
turns off.
PB016461 - ES-LL2141-K551 ������_(01EN)_08-01-18.indd 11 2018/8/1 17:25:19