12
How to use
Using the shaver
1. Press and shave.
• The “shaving sensor”, which automatically
adjusts the power depending on the beard
thickness, will operate.
It will shave with high power on areas where
the beard is heavy, and reduce the power on
areas where the beard is thin, to reduce
burden on the skin.
• The power cannot be turned on when the switch lock
lamp ( ) blinks, as the power switch is locked.
Press the power switch for more than 2 seconds to
unlock.
(See page 13.)
Tips for better shaving
Apply the whole system outer foil
perpendicularly against the skin and
shave by slowly gliding the shaver over
the face against the grain of the beard.
• The beard under the chin and around
the throat can be shaved better by
stretching the skin so the beard will
stand.
• To prevent damaging the system
outer foil, do not shave with only a
part of the system outer foil.
2. Press when nished.
While using
The shaving sensor lamp ( ) blinks.
When the battery capacity is low
The battery capacity lamp ( ) blinks for 5 seconds when
the power switch is pressed. The appliance beeps twice
after switched off.
• You can shave 2 to 3 times after the battery capacity lamp
( ) blinks. (This will differ depending on usage.)
Notes
• The appliance may not operate in an ambient temperature
lower than approximately 5 °C (41 °F).
• The shaving sensor may not respond depending on the type
and quantity of the shaving gel. This is not abnormal.
• Depending on the beard thickness or the amount of beard
trimmings in the shaver head, the shaving sensor may not
react and the driving sound may not change. This is not
abnormal.
PB016461 - ES-LL2141-K551 ������_(01EN)_08-01-18.indd 12 2018/8/1 17:25:20
To Next Page
Loading...
