Panasonic EW3006 - Irregular Pulse Detection Function

31
TAKING A READING (CONTINUED)
IRREGULAR PULSE DETECTION FUNCTION
If the heart rate measured exceeds the average value for more than
+25% during measurement, the symbol of "Irregular Pulse" will be
displayed to remind that atttention is needed after measurement.
。 After measurement, the symbol of "Irregular Pulse" will be displayed after
6 seconds of blinking.
* When the symbol of "Irregular Pulse" is displayed, please measure again.
«lf the heart rate changes too much during measurement, it may affect the
accuracy of measured value.
Flashes.
Is lit
* Blood pressure values are displayed alternately in mmHg and kPa units.
e When you save and select the value measured with irregular pulse,
the symbol of "Irregular Pulse" will be displayed as well.
This symbol is not designed to indicate irregular pulse.
e This is a reference function intended for ensuring the accuracy of
measured value. In order to ensure the accuracy of measurement,
please measure for 2-3 times under static status even if the symbol
of "Irregular Pulse" is not displayed.(see.p.27)
e If the symbol appears constantly, you should consult a doctor regarding
your health condition.
Please do not estimate the result and receive treatment by
yourself; Doctor's advice must be followed.
Reading the blood pressure display
Whether the systolic and diastolic blood pressure values are in the high
blood pressure region or normal blood pressure region are judged based
on the WHO/ISH(Word Health Organization/International Society of
Hypertension)blood pressure classifications,and the blood pressure value
blinks if required.
WHO/ISH blood pressure classifications% |
90 Diastolic
(mmHg)
If the measured blood pressure value is in the high blood pressure
region,the values will blink for approximately 6 seconds.
+ Systolic blood pressure:18.7kPa (140mmHg) or higher
* Diastolic blood pressure:12.0kPa (90mmHg) or higher
(Only immediately after measurement) (1kPa=7. 5mmHg)
If measurements could not be taken properly
85
The remeasure mark "E" will displayed.
When taking successive measurements, press the
开始 /结束 button to switch off the blood pressure
monitor once and stay quiet for 4 to 5 minutes,and
then take the next measurement.
Advice:
Often with the second measurement,there is less tension and you feel
more relaxed,so the blood pressure value is lower.
For people who easily get tense,measuring twice each time is very
effective. When two measurements are taken,normally the smaller
measurement is stored.When taking two measurements,always stay
quiet for 4 to 5 minutes after the first measurement before taking the
second measuremnt.
*4 1999 World Health Organization-International Society of Hypertension
Guidelines for the Management of Hypertension
32