Panasonic EW3006 - Storing And Recalling Measurement Values

STORING AND RECALLING MEASUREMENT VALUES
EW3006 can store up to 90 measurement values.
EW3005 can store up to 21 measurement values.
Storing measurement values
Stored data will remain in memory even if batteries become exhausted or
batteries are removed.
L ge |
可
After measurement ,Press the
记忆 / 调 出 button while the
mark is blinking.
Storing is completed
Up to 90 measurement values can
be stored by EW3006 ,up to 21
measurement values canbe stored
by EW3005. When the memory is full
and additional values are stored, the
oldest value in memory will be
deleted and the new value will be
stored. At that time,the data numbers
for the measurement values will
change.
slf measurements could not be taken
properly (the "E" mark is shown
instead of the blood pressure value),
measurement values cannot be
stored. Data numbers will not be
changed.
However, if only the pulse rate vallue
shows the "E" mark, measured blood
pressure values can be stored.
Recalling measurements
Measurements can be recalled after measurement is completed or after
the power has been switched off.
v
W (After second)
2
Press the 记忆 / 调 出 button.
sThe average of all measured values
in memory will be shown.
The mark will be lit.
For example,if 90 measured values
are stored,the average of 90
measurements will be shown. (If only
1 measurement is stored, the gm mark
will not be show.)
If you press the 记忆 / 调 出 button again,
the most recent stored measurement
value will be shown.
*Each time the iziZ/i# button is
pressed, the stored measurement
values will be recalled in order,
starting with the most recent.
elf no measurement value is stored,
the value will not be displayed.
To switch off the blood pressure
monitor, Press the 开始 /结束 button.
If you forget to switch off,the blood
pressure monitor, it will switch off
automatically after approximately 30
seconds.
To erase all measured values stored in memory;
@pPress the 记忆 / 调 出 button to recall stored measurement values.
@Press the 记忆 / 调 出 button again and hold it pressed until the
measurement values disappear (longer than approximately 3 seconds).
*lt is not possible to erase single measurement values.
@When all measurement values have been deleted,
the M) mark and wo.89 will be displayed.
34