22
Tray
Care and maintenance
Before cleaning
Be sure to
disconnect the power
plug.
Do not use the detergent other than the neutral one for
kitchen purpose. (Deterioration, deformation or breakage
of plastic parts may occur.)
You can use the oxygen-based bleaching agent only when
cleaning the humidifying filter.
When using chemically treated cloth, follow its instructions.
To remove the stubborn stains
How to soak and wash
Dissolve neutral detergent for kitchen purpose or
citric acid well in warm water (below about 40 °C).
Soak the parts for 30 minutes. Rinse with clean
water 2 to 3 times.
Rinse enough, otherwise, the remaining detergent
may smell or failure may occur.
Tray
Filter frame
Wash with water containing the
neutral detergent for kitchen purpose
or citric acid.
(Ion sterilization
unit section)
Soaking
Humidifying
filter
After soaking, press and wash.
The ratio of citric acid to warm water is 20 g to 3 L.
*1 As the dirtiness varies depending on the water
quality, maintenance may be required even
within one month after the last maintenance. If
it smells unpleasant or water in the tray
decreases less than before, clean the tray.
Attention
Do not operate without the humidifying filter.
(It makes it impossible to humidify the air.)
Drain after removing the tray. Do not drain with the tray installed.
(Water may enter inside the body, and failure may occur.)
Tray
<About once a month>*
1
Wash with water.
Floater
Wipe the dirt in details with cotton
swab or toothbrush.
Do not remove the floater (polystyrene
foam).
Stubborn stains
(To remove the stubborn stains)
Tray
VXL40M_EN_ARA.indd 22 9/30/2015 2:58:02 PM
To Next Page
Loading...
